Can't connect Wi-Fi on Linux Mint 14
I have got Linux Mint 14 and everything worked fine until today. Today I installed and configured a new router I bought recently, then I tried to connect it. I clicked on the router name in the list in the bottom right corner, but nothing happened. I can see all the routers around, but as I click on any of them in the list, nothing happens. As I mentioned, it doesn't depend on router. System doesn't show that it tries to connect the router, otherwise there would a bold dot near router name appear.
And as I said, it worked earlier. I didn't make any notable manipulations on system last time, so I can't give any other advice.
Some information on my system:
CPU: Dual core Pentium CPU T4300 (-MCP-) clocked at 1200.00 MHz
Network: Card-1: Broadcom BCM4312 802.11b/g LP-PHY driver: wl
IF: eth1 state: dormant mac: 00:26:82:3c:29:99
Card-2: Broadcom NetLink BCM5906M Fast Ethernet PCI Express driver: tg3
IF: eth0 state: up speed: 100 Mbps duplex: full mac: 00:26:22:d7:83:7b
Network controller: Broadcom Corporation BCM4312 802.11b/g LP-PHY (rev 01)
Ethernet controller: Broadcom Corporation NetLink BCM5906M Fast Ethernet PCI Express (rev 02)
Thanks in advance!
I have got Linux Mint 14 and everything worked fine until today. Today I installed and configured a new router I bought recently, then I tried to connect it. I clicked on the router name in the list in the bottom right corner, but nothing happened. I can see all the routers around, but as I click on any of them in the list, nothing happens. As I mentioned, it doesn't depend on router. System doesn't show that it tries to connect the router, otherwise there would a bold dot near router name appear.
And as I said, it worked earlier. I didn't make any notable manipulations on system last time, so I can't give any other advice.
Some information on my system:
CPU: Dual core Pentium CPU T4300 (-MCP-) clocked at 1200.00 MHz
Network: Card-1: Broadcom BCM4312 802.11b/g LP-PHY driver: wl
IF: eth1 state: dormant mac: 00:26:82:3c:29:99
Card-2: Broadcom NetLink BCM5906M Fast Ethernet PCI Express driver: tg3
IF: eth0 state: up speed: 100 Mbps duplex: full mac: 00:26:22:d7:83:7b
Network controller: Broadcom Corporation BCM4312 802.11b/g LP-PHY (rev 01)
Ethernet controller: Broadcom Corporation NetLink BCM5906M Fast Ethernet PCI Express (rev 02)
Thanks in advance!
No comments:
Post a Comment